Boost gauge piping

[UltraFlynn]

The time has come to reinstate by boost gauge. I realise that it's in the most ridiculous place possible but for the time being, that's life.

What I need is a few metres of piping to connect up my gauge to the T-piece near the inlet manifold. I'm planning on plumbing it in exactly as it used to be.

Can someone recommend somewhere to source the tubing from? And also give me a guide as to what I have to order?

[suprarob]

I assume you are using the black tubing matt. If so you can get vacuum tube from any car parts/motor factors or Halfrauds place

I can,t remember the inside diameter of the tubing I used but at a guess I would say 4mm.

Or

you could take along your 'T' piece and gauge to the shop and see what fits

[UltraFlynn]

you could take along your 'T' piece and gauge to the shop and see what fits

I think that's going to be the best plan. I may even remove the boost gauge as well and make sure that everything fits correctly.

[Sharpie]

http://www.blitz-uk.co.uk/ProductItem-323.aspx

[UltraFlynn]

Hey, thanks for that. I was thinking about my boost gauge only yesterday.

[jay200bhp]

demontweeks sell vacuum tubing by the metre too!